Dedicated Subsystem WorkbenchPlatform Gen: 2014–2026
2026 Indian Motorcycle Chieftain / Roadmaster / Limited / Elite Charging System, Stator AC Output & Battery Health
Stator 3-phase AC voltage at 5,000 RPM, coil resistance, regulated DC voltage, battery code YTX20HL-BS, CCA rating, and multimeter charging diagnostic steps for 2026 Indian Motorcycle Chieftain / Roadmaster / Limited / Elite.
Gen 2014–2026
Factory Platform Compatibility: All workshop fluid capacities, maintenance milestones, torque specifications, and consumables on this specification sheet are factory-identical across model years 2014 through 2026.
Engine
1890cc
Drive
Not Available
Cooling
Air-Cooled with Integrated Oil Cooler and Rear Cylinder Deactivation
3-Phase Charging System & Battery Diagnostic Flowchart
Yuasa & OEM StandardsMultimeter troubleshooting protocols, cold cranking amps (CCA) ratings, 3-phase stator AC outputs, and regulator-rectifier health verification.
OEM Battery Code
YTX20HL-BS
Cold Cranking Rating
Not Available
Capacity (10HR Rate)
Not Available
Regulated Output Spec
Key-OFF Parasitic Limit
V DC
Multimeter Test Diagnosis
Enter your multimeter terminal reading on the left to view instant diagnostic interpretations and recommended workshop actions.
OEM Factory AGM BatteryOEM Replacement
Dimensions: • Weight: Not Available. Pre-filled absorbed glass mat technology engineered for heavy vibration resistance.
Lithium LiFePO4 UpgradeUp to 70% Lighter
Features built-in RE-START jump starting reserve. Never stranded by dead lights: press the restart button on the top terminal to crank the motorcycle without jumper cables.
Smart Maintainer SpecBattery Life Extension
Standard Charge Rate: . Automated desulfation & float maintenance ensures full capacity retention during off-season winter storage.
Recommended Parts: •
Indian Motorcycle Diagnostic Fault Codes & Multimeter Bench Testing
FI & OBD2 DecoderAuthentic factory ECU fault codes, sensor resistance specifications, and harness pinout troubleshooting.
Code P0107Manifold Absolute Pressure (MAP) Sensor
MAP sensor circuit low voltage or vacuum signal disconnected.
Test: Check 5.0V VRef and sensor output 2.5-3.0V DC at atmospheric key-on.
Code P0117Engine Coolant / Head Temp (ECT / EHT)
Engine temperature sensor circuit low voltage or thermistor shorted.
Test: Measure thermistor: ~2.5 kΩ at 20°C (68°F); 280-320 Ω at 80°C (176°F).
Code P0122Throttle Position Sensor 1 (TPS / APS)
Ride-by-wire electronic throttle body position track 1 low voltage.
Test: Check TPS 1 (0.5-4.5V) linear sweep; verify return spring mechanically snaps closed.
Code P0335Crankshaft Position Sensor (CKP)
Zero timing sync pulses detected from 60-2 tooth reluctor wheel during starter cranking.
Test: Measure inductive pickup coil resistance: 560-680 Ω across 2-pin harness connector.
Code P0705Transmission Gear Position Sensor (GPS)
Gear position switch circuit invalid voltage or open circuit between neutral detents.
Test: Measure resistance in each gear: Neutral (~0 Ω), 1st through 6th distinct stepped resistance.
Code P1600ECM Internal / CAN Bus Communication Timeout
CAN communication lost between Bosch / Polaris ECM, VCM, and Ride Command TFT display.
Test: Measure 60 Ω CAN bus termination resistance between CAN-H (Yellow) and CAN-L (Green).
Looking for other error codes, sensor pinouts, or OBD2/Euro 5 codes?
OEM Workshop Archives
3 Documented BulletinsOfficial Factory Service Bulletins & Field Updates
Bulletin #I-19-05Safety Recall Bulletin I-19-05 / NHTSA 19V-882: Indian Heavyweight & FTR 1200 10A Circuit Breaker Triad Upgrade (PN 4011371)
Source: RCRIT-19V882-6411.pdfMandated Torques:Torque: 8.5 N·m (75 in-lb) (Right V-Cover Chrome Fasteners)Torque: 5 N·m (44 in-lb) (Fuse Box Carrier Bracket Screws)
Consumable Specs:Dielectric Silicone Terminal Grease
Genuine Part Numbers:40113714011371-RD2411993
Recalls 22V-837 & 19V-882Thunderstroke 111 / 116 Platform
Indian Thunderstroke Fuel Pump & 10A Circuit Breaker Architecture
Fuel pump star torque sequence (5 N·m), red-dot circuit breaker triad (PN 4011371), tank mounts (10 N·m), and dual drain plugs (20 N·m).
Click on Fuel Pump Flange, Viton Seal, Tank Mounts, 10A Circuit Breakers, or Dual Drain Plugs to view technical specs.
Bulletin #I-24-07Safety Recall Bulletin I-24-07 / NHTSA 24V-550: Challenger, Pursuit, Chieftain & Springfield Heavy-Duty Rear Suspension Pushrod Replacement
Source: RCAK-24V550-7267.pdfMandated Torques:Torque: 80 N·m (59 lb-ft) (Upper & Lower Suspension Pushrod Link Bolts)Torque: 88 N·m (65 lb-ft) (Rear Axle Nut)Torque: 12 N·m (106 in-lb) (Belt Adjuster Jam Nuts)
Consumable Specs:Loctite 243 Medium Strength ThreadlockerMoly Paste 65
Genuine Part Numbers:514489275199827556153
Safety Recall 24V-550 / Bulletin I-24-07PowerPlus 108ci Platform
Indian Challenger & Pursuit Inverted 43mm Fork & Pushrod Architecture
Inverted fork pinch bolts (24 N·m), front axle (75 N·m), Brembo radial calipers (50 N·m), and heavy-duty pushrod link (80 N·m).
Click on Triple Clamps, Front Axle, Rear Pushrod Linkage, or Brembo Caliper to view engineering torque specs.
Bulletin #I-16-02Safety Recall Bulletin I-16-02 / NHTSA 16V-446: Thunderstroke 111/116 3-Cam Engine Misfire & Exhaust Temperature ECM Calibration
Source: RCAK-16V446-3002.pdfMandated Torques:Torque: 18 N·m (13.3 lb-ft) (NGK DCPR8E Dual Spark Plugs)Torque: 11 N·m (97 in-lb) (Rocker Arm Carrier & Pushrod Lifter Blocks)Torque: 20 N·m (14.8 lb-ft) (Dual Oil Drain Plugs - Sump & Transmission)
Consumable Specs:Polaris PS-4 Extreme 15W-60 Synthetic Oil (5.20 L)Dielectric Spark Plug Boot Grease
Genuine Part Numbers:NGK DCPR8E54146115414612
Factory Engineering SpecificationThunderstroke 111 / 116 ci
Indian Chief Thunderstroke 3-Cam Gear Train & Pushrod Valvetrain
Helical gear-driven 3-cam valvetrain, zero-lash hydraulic roller lifters, dual-plug heads (18 N·m), and 11 N·m rocker/lifter torque specs.
Click on Crank Pinion, 3-Cam Gears, Hydraulic Lifters, Pushrod Tubes, or Dual Spark Plugs to view technical specs.
Explore Other Subsystems for this 2026 Indian Motorcycle Chieftain / Roadmaster / Limited / Elite
Jump straight into dedicated factory specifications and interactive workshop diagnostic engines.
Subsystem Guide/torques
Fastener Torques
Engine drain plug, axle spindles, caliper mounts, triple clamp pinch bolts & thread lubrication derating guide.
Open Dedicated Workbench →
Subsystem Guide/fluids
Fluids & Capacities
Oil: 5.20 L (5.50 US qt) • Coolant: Air-Cooled Architecture • Brake: N/A
Open Dedicated Workbench →
Subsystem Guide/fuses-relays
Fuses & Relays
Main: N/A • Location: N/A
Open Dedicated Workbench →
Subsystem Guide/compression
Compression & Leakdown
Ratio: N/A
Open Dedicated Workbench →
Subsystem Guide/valves
Valve Clearances
Intake: N/A mm • Exhaust: N/A mm
Open Dedicated Workbench →
Subsystem Guide/fuel-delivery
Fuel Delivery & TB Sync
Idle: N/A • Rail Pressure: N/A • Vacuum: N/A
Open Dedicated Workbench →
Subsystem Guide/tires
Tires & Gearing
Front: 130/60B19 61H • Rear: 180/60R16 80H
Open Dedicated Workbench →
Subsystem Guide/suspension
Suspension & Sag
Front Travel: N/A • Rear Travel: N/A
Open Dedicated Workbench →
Subsystem Guide/maintenance
Maintenance Schedule
Oil: N/A • Valves: N/A • Plugs: N/A
Open Dedicated Workbench →
Looking for direct-fit parts for this 2026 Chieftain / Roadmaster / Limited / Elite?
Browse authentic verified parts, motor oils, filters, brake pads, and tires that fit this exact bike.